Typical doorstep service scenarios handled for Elica kitchen chimneys across residential societies in Ghaziabad (labelled as illustrative repair examples, not verified customer testimonials):
Elica Chimney Repair in Indirapuram (Vaibhav Khand) — Illustrative Case
Reported Problem: Chimney stopped heating during the auto-clean cycle; oil was not draining into the collector tray.
Customer's Concern: “Filterless chimney hone ke bawajood cooking ke time kitchen mein smoke bhar raha tha.”
Technician's Inspection: Blower chamber walls were caked with sticky grease; flexible aluminium duct pipe had two sharp bends restricting airflow.
Parts Checked: Heating element, control PCB relay, thermal fuse, and oil collector drain.
Repair Work Done: Degreased blower housing thoroughly and realigned the 6-inch aluminium duct with a direct exit route.
Estimated Cost: Parts: ₹700 | Labour: ₹400 | Total: ₹1,100
Repair Outcome: Heating element warmed the housing properly, liquefying oil smoothly into the stainless steel collector.
Elica Chimney Repair in Vaishali (Sector 4) — Illustrative Case
Reported Problem: Customer reported an unusual buzzing sound that ruined the chimney's silent operation.
Customer's Concern: “Auto-clean button dabane par buzzer toh bajta tha par heating bilkul nahi ho rahi thi aur tray khali rehti thi.”
Technician's Inspection: Heating coil had burnt open; thermal cut-off thermostat had tripped.
Parts Checked: Acoustic dampeners, blower bracket, motor bearings, and duct collar.
Repair Work Done: Replaced the burnt heating strip and reset the safety thermal fuse.
Estimated Cost: Parts: ₹250 | Labour: ₹350 | Total: ₹600
Repair Outcome: Silent operation was fully restored; blower ran with minimal decibel output.
Elica Chimney Repair in Vasundhara (Sector 14) — Illustrative Case
Reported Problem: Cooking smoke was billowing back into the kitchen, and oil was dripping onto the gas stove.
Customer's Concern: “EDS3 silent chimney achanak vibration ke sath bohot heavy gungunahat karne lagi thi.”
Technician's Inspection: Acoustic insulation foam was soaked with oil; motor rubber damping bushes had perished.
Parts Checked: Baffle filters, oil collection channel, fan impeller, and aluminium duct.
Repair Work Done: Replaced motor damping grommets and cleaned the internal acoustic chamber.
Estimated Cost: Parts: Nil | Labour: ₹499 (deep clean) | Total: ₹499
Repair Outcome: Airflow velocity returned to normal; all cooking smoke was drawn outside without any dripping.
Elica Chimney Repair in Kaushambi — Illustrative Case
Reported Problem: Touch controls became unresponsive; waving hand in front did not trigger speed changes.
Customer's Concern: “Chimney ke round oil collector cup ke kinare se kala tel seedha burner par tapak raha tha.”
Technician's Inspection: Oil collector cup locking thread was cracked; grease drain spout was choked with hardened oil.
Parts Checked: Touch control board, ribbon connector, gesture sensor eye, and front glass.
Repair Work Done: Fitted a replacement oil collector cup and cleared the internal gravity drain spout.
Estimated Cost: Parts: Nil | Labour: ₹350 | Total: ₹350
Repair Outcome: Touch buttons and gesture wave sensor functioned instantly with high responsiveness.
Elica Chimney Repair in Raj Nagar Extension (Officer City) — Illustrative Case
Reported Problem: Fan motor hummed loudly but would not rotate upon pressing the speed buttons.
Customer's Concern: “Touch panel par power button lagatar beeping sound kar raha tha par motor start nahi ho rahi thi.”
Technician's Inspection: Moisture and oil had seeped into the capacitive touch sensor PCB, causing a short circuit.
Parts Checked: Start capacitor, motor winding resistance, shaft free movement, and push switches.
Repair Work Done: Cleaned and moisture-sealed the touch panel circuit and replaced the corroded SMD capacitor.
Estimated Cost: Parts: ₹200 | Labour: ₹250 | Total: ₹450
Repair Outcome: Motor started smoothly and spun up to full operating speed without any hesitation.
Elica Chimney Repair in Crossings Republik (Ajnara Gen-X) — Illustrative Case
Reported Problem: Both LED spotlight lamps stopped illuminating during evening cooking hours.
Customer's Concern: “Speed 1 par motor jhatke le kar band ho jati thi jabki speed 3 par normal ghumti thi.”
Technician's Inspection: PCB speed regulation triac for low speed was damaged by power fluctuations.
Parts Checked: LED driver transformer, spotlight wiring, and PCB light relay.
Repair Work Done: Serviced the main control PCB and replaced the damaged speed triac component.
Estimated Cost: Parts: ₹280 | Labour: ₹200 | Total: ₹480
Repair Outcome: Both spotlights illuminated brightly with steady, flicker-free lighting.